“shear stress”可以造什么句，shear stress造句

Based on the expression of the relation among focal peak value, acceleration and environmental shear stress field, the environmental shear stress values in South Tianshan, Xinjiang are calculated.

The study results show that generalized shear stress has a strong nonlinear relation with generalized shear strain, and intermediate principal stress has interval effect on soil strength.

The height of the sh, ear fine has little influence on the shear stress.

The results show that strength of NEPE solid propellant under multi-axis stress state is related to strain; octahedral shear stress nonlinearly increases with the average main stress.

The clearance sites had influence not on the peak values of shear stress, peel stress and equivalent stress, but on the occurrence point of those items.

The interface between two molten polymers, as well as the distribution of flow rate, shear rate and shear stress were obtained by using an iterative calculating scheme .

Secondly, in conditions of non-steady flow, azinuthal velocity and shear stress distribution were deduced according to function approximation method.

There are controversial ideas how vascular wall shear stress take an effect on plaque in carotid artery and its stability.

This study shows that the formation of antithetic normal fault is controlled by NE WS strike tensile stress and dextral shear stress and the strike is nearly vertical to the tensile stress.

Effect of shear stress on the expression of c-fos and c-myc mRNA in cultured human retinal pigment epithelial cells

In the photoelastic coating methods, the shear stress difference and slant incident approaches are often used to divide the main strains.

The software ANSYS and MATLAB were employed to analyze and simulate the velocity, pressure, shear stress and viscosity distribution in fishtail sheet extruder die based on the three-dimensional FEM.

Interfacial shear stress is adopted to evaluate and measure the complex interface bonding strength in Al/ Cu bimetal tube plug drawing, a set of apparatuses had specially been designed and used to measure complex interface bonding strength according to the principle.

The torsion resistance of the tension bar and the calculatiolls of bending shear stress, free torsional shearstress and bending torsional shear stress on the section are also discussed.

These drastic changes of superconductivity were mainly due to the shear stress under quasi-hydrostatic pressure.

The stress accumulation in the southeastern segment of the fault since 1893 has been calculated, and the corresponding contours of maximum shear stress and hydrostatic stress are shown.

However, as the interface was fully damaged, shear stress would decrease to a certain degree, and the residual shear stress nearly kept a constant value which equal to the friction force.

The maximum principal stress and maximum shear stress trajectory both divert near the fault and among the rock mass which is surrounded by the fault and form some range of displacement of stress;

By adjusting the starch milk concentration, temperature and drum speed to adjust the product capability of resistance to shear stress, the drying process of aging and viscosity.

The amount of the departure may not necessarily be large, but it results in the larger errors when the profiles are used to calculate the bed roughness length and shear stress.

The strength resisting liquefaction increases along with the increase of consolidation pressure, sample density initial shear stress, but the increase of initial shear stress is limited.

The damage processes revealed that heterogeneity is the source of nonlinear deformation, and high shear stress is the reason of shear damage.

Controlled by sinistral shear stress of the regional major fault during magma emplacement, the granite distributed from the southeast to the northwest.

The Reynolds stresses of drag-reducing fluid were contrasted with those of Newtonian fluid, which showed that the Reynolds shear stresses of drag-reducing fluid decreased drastically.

Through deduction to the constitutional equation of viscosity, field and shear stress field of the runner were achieved.

That shear stress, resolved within a slip plane and direction, which is required to initiate slip.

Through solving the blood flow equations for local vessel expansion region, the analytical expressions of blood flow velocity, pressure and wall shear stress were then obtained.