“MFR”可以造什么句，MFR造句

2、The result of MFR showed that the compounded fire-retardant with 40 PHR could meet the needs of processing craftwork.

4、There are several models for the problem: Minimum Fragment Removal (MFR) problem, Minimum SNP Removal (MSR) problem, and Minimum Error Correction (MEC) problem.

6、The influences of different initiators and their concentrations on grafting ratio and the melt flow rate (MFR ) of the grafted polymer were studied.

8、研究了引发剂种类及用量对接枝率和接枝物熔体流动速率（MFR）的影响。

10、熔体流动速率(MFR)的测定表明当复合阻燃剂的添加量为40份时，仍能满足加工工艺的要求。

12、通过熔体流动速率(MFR)、挤出胀大比(SR)以及动态流变数据等表征方法，研究了退火工艺对剪切改*样品流变*能的回复作用。

1、OBJECTIVE: to observe the protection of the effective fraction of Hibiscus Mutabilis L. (MFR) on renal ischemic reperfusion injury in rats to probe into the mechanism of MFR on anti inflammation.

5、The results show that the tensile strength, breaking elongation, impact strength and MFR of nylon 6 increase simultaneously after some PAMAM were added. The optimum increment is 1.0%.

9、By testing the MFR of silane grafted PE with different preservation time, and the surface condition and the gel content of the silane grafted extrudates with different retention time in extruder.

13、实验结果表明：产物的接枝率和熔体流动速率（MFR）变化与聚乙烯的种类有直接关系，接枝*能从优到差的顺序为： LDPE>LLDPE>HDPE；

7、Even though MFR values are measured at an unrealistically low shear rate, it might seem that the test would accurately rank different materials for comparative ease of flow.

3、MFR did not take the models too literally and was one of the few firms to have been appropriately pessimistic.

11、实验结果表明：产物的接枝率和熔体流动速率（MFR）变化与聚乙烯的种类有直接关系，接枝*能从优到差的顺序为：LDPE>LLDPE>HDPE；